Xm serial configuration utility software, Application help, Chapter 2 – Rockwell Automation 1440-SDM02-01RA XM-124 Standard Dynamic Measurement Module Manuel d'utilisation
Page 59: Chapter
Rockwell Automation Publication 1440-UM001C-EN-P - May 2014
59
Chapter
2
Configure the XM-124 Standard Dynamic
Measurement Module
The XM-124 module is configured by using the XM Serial Configuration Utility
software. This section details the configuration process and associated
parameters.
XM Serial Configuration
Utility Software
The Serial Configuration Utility is a tool provided for you to locally configure
any XM Series module, except for the 1440-DYN02-01RJ Dynamic
Measurement Module, which is used exclusively with and configured from a
Logix controller. The tool is available on the Rockwell Automation Support for
XM website:
.
The Serial Configuration Utility, versions 7.0 and later, includes support for the
XM-124 standard dynamic measurement module.
The Serial Configuration Utility is a Microsoft Windows-based program that
enables configuring XM modules via the module’s serial port (usually the micro
connector on the top of the module). Besides configuring a module the tool also
enables reading and writing configuration files, displaying data being measured by
a module and updating a module’s firmware.
Application Help
At any time, you can press the F1 function key to access the online help function
for the application. When opened, the Help function presents information
relative to the tab currently being viewed.
Topic
Page
XM Serial Configuration Utility Software