Rockwell Automation 1440-SDM02-01RA XM-124 Standard Dynamic Measurement Module - Manuel (Page 139)

Rockwell Automation Publication 1440-UM001C-EN-P - May 2014 139
CIP Objects Appendix B
Services
(1) Attributes can only be set while the device is in Program mode. See the description of the Device Mode Object for more information.
7 Get/Set Internal Gear Teeth UINT The number of gear teeth on the
shaft of interest. The Internal/External Gear Teeth
values are used when synchronous
operation is selected but there is a known
speed difference between the shaft of
interest and the shaft used as the
tachometer source.
8 Get/Set External Gear Teeth UINT The number of gear teeth on the
shaft used as the tachometer
source.
9 Get/Set Name STRING2 A name to help identify this
channel.
10 Get/Set Full Scale REAL The maximum signal expected to
be processed by the channel. It is set according to the
Output Data Units attribute on page 138 .
Setting the Full Scale to a greater value
enables the channel to handle greater
input signals without saturating or
clipping. Setting the Full Scale to a lesser
value enables the signal to be measured
with greater resolution.
100 Get Very Low HPF Corner
Frequency REAL The frequency, in Hz, of the ‘Very
low’ Low Cutoff Frequency
option for attribute 5. Hz
101 Get Low HPF Corner
Frequency REAL The frequency, in Hz, of the "Low"
Low Cutoff Frequency option
for attribute 5. Hz
102 Get Medium HPF Corner
Frequency REAL The frequency, in Hz, of the
"Medium" Low Cutoff
Frequency (low frequency
corner) option for attribute 5. Hz
103 Get High HPF Corner
Frequency REAL The frequency, in Hz, of the "High"
Low Cutoff Frequency option
for attribute 5. Hz
104 Get Very High HPF Corner
Frequency REAL The frequency, in Hz, of the "Very
high" Low Cutoff Frequency
option for attribute 5. Hz
105 Get Channel Alarm Status USINT Summary of the Alarms
configured for this channel. 0 = Normal
1 = Alert (alarm)
2 = Danger (shutdown)
3 = Disarm
Table 59 - Channel Object Instance Attributes
Attr ID
Access Rule
Name Data Type Description Semantics
Table 60 - Channel Object Services
Service Code
Class/Instance Usage Name Description
0E
h
Instance Get_Attribute_Single Returns a single attribute.
10
h
Instance Set_Attribute_Single Sets a single attribute. (1)