Rockwell Automation 1440-SDM02-01RA XM-124 Standard Dynamic Measurement Module - Manuel (Page 137)

Rockwell Automation Publication 1440-UM001C-EN-P - May 2014 137
CIP Objects Appendix B
Instance Attributes
Services
(1) Attributes can only be set while the device is in Program mode. See the description of the Device Mode Object for more information.
4 Channel 2 Band Measurement #2
5 Channel 1 Band Measurement #3
6 Channel 2 Band Measurement #3
7 Channel 1 Band Measurement #4
8 Channel 2 Band Measurement #4
9 Channel 1 Band Pass Measurement
10 Channel 2 Band Pass Measurement
Table 56 - Band Measurement Object Instances
Instance Description
Table 57 - Band Measurement Object Instance Attributes
Attr ID Access Rule Name Data Type Description Semantics
3 Get Band Value REAL The measured band value. See Data Units
4 Get Status BOOL Indicates if a fault or alarm has
occurred. 0 = Operating without alarms or faults
1 = Alarm or fault condition exists, the
Band Value attribute may not represent
the actual field value.
5 Get Data Units ENGUNIT The units context of the Band
Value attribute. This attribute is read only. It is set
according to the Output Data Units
attribute of the associated Channel Object
instance. See
page 138 .
6 Get/Set Measurement USINT The measurement (or calculation)
performed to produce the Band
Value. 0 = RSS
1 = Peak
7 Get/Set Minimum Frequency REAL The minimum frequency that is
included in the band
measurement.
8 Get/Set Maximum Frequency REAL The maximum frequency that is
included in the band
measurement. The Maximum Frequency must be greater
than or equal to Minimum Frequency.
9 Get/Set Frequency Units USINT The units of Minimum and
Maximum Frequency. 0 = Hz
1 = Orders
Table 58 - Band Measurement Object Services
Service Code
Class/Instance Usage Name Description
0E
h
Instance Get_Attribute_Single Returns a single attribute.
10
h
Instance Set_Attribute_Single Sets a single attribute. (1)