Rockwell Automation 1440-SDM02-01RA XM-124 Standard Dynamic Measurement Module - Manuel (Page 104)

104 Rockwell Automation Publication 1440-UM001C-EN-P - May 2014
Chapter 3 Operate the Module
COS Message Format
The XM-124 module’s COS message contains 8 bytes of data as defined in the
table below. The COS data can also be requested explicitly through Assembly
Object (Class ID 0x4), Instance 100 (0x64), Data Attribute (3).
XM Status Values
The following tables describe the XM Status values that are included in the COS
messages.
Table 17 - XM-124 COS Message Format
Byte Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0
0 Relay 1 Status Setpoint Multiplier
Status
Alarm 2 Status Alarm 1 Status
1 Relay 2 Status Channel 1 Transducer
Status Alarm 4 Status Alarm 3 Status
2 Relay 3 Status Channel 2 Transducer
Status Alarm 6 Status Alarm 5 Status
3 Relay 4 Status Tachometer
Transducer Status Alarm 8 Status Alarm 7 Status
4 Relay 5 Status Reserved Alarm 10 Status Alarm 9 Status
5 Reserved Reserved Alarm 12 Status Alarm 11 Status
6 Reserved Reserved Alarm 14 Status Alarm 13 Status
7 Reserved Reserved Alarm 16 Status Alarm 15 Status
Table 18 - Alarm Status Descriptions
Alarm Status Value Description
0 Normal
1 Alert
2 Danger
3 Disarm
4 Transducer Fault (Sensor OOR)
5 Module Fault
6 Tachometer Fault
7 Reserved
Table 19 - Setpoint Multiplier Status Descriptions
Setpoint Multiplier Status Value Description
0 Not Activated
1 Activated