Rockwell Automation 1440-SDM02-01RA XM-124 Standard Dynamic Measurement Module Manuel d'utilisation
Page 44
44
Rockwell Automation Publication 1440-UM001C-EN-P - May 2014
Chapter 1
Install the XM-124 Standard Dynamic Measurement Module
Figure 27 - Two IEPE Accelerometers and a Non-contact Sensor Wiring
Connect a Velocity Sensor and Two Non-contact Sensors
The following figure shows the wiring of a velocity sensor and two non-contact
sensors to the terminal base unit. The velocity sensor is wired to channel 1. The
first non-contact sensor is wired to channel 2, and the other non-contact sensor is
wired to the tachometer input signal.
IMPORTANT
A jumper from terminal 5 to terminal 6 is required for channel 1 buffered
output. A jumper from terminal 22 to terminal 6 is required for channel 2
buffered output.
See Connect the Buffered Outputs on page 33
TYPICAL WIRING FOR TWO IEPE ACCELE ROMETERS AND
NON-CONTACT SENSOR TO XM-120/121 DYNAMIC MEASUREMENT MODULE
Shield
Pin A - Signal
Pin B - Common
Cable s hield not
connected at this end
0
16
22
6
21
Channel 1 Input Signal
Signal Common
5
37
SIG
-24
COM
17
1
Signal Common
Channel 2 Input Signal
-24V DC
Pin A - Si gnal
Pin B - Common
Cable shiel d not
connected at this end
Shield
36
20
4
Tach Input Signal
Signal Common
31
Shield
Shield
Fl oating
Isolated Sensor Driver
*
*
* Note: Jumpering terminal 5 to terminal 6
configures CH 1 buffer (-5V to +24V)
Jumpering terminal 22 to terminal 6
configures CH 2 buffer (-5V to +24V)
18
TYPICAL WIRING FOR TWO IFPF ACCELEROMETERS AND
NON-CONTACT SENSOR TO XM-124 STANDARD DYNAMIC MEASUREMENT MODULE
ATTENTION: You may ground the cable shield at either end of the cable.
Do not ground the shield at both ends. Recommended practice is to
ground the cable shield at the terminal base and not at the transducer.
Any convenient chassis terminal may be used (see
).