Metrohm 730 Sample Changer - Manuel (Page 28)

2.5 Integration
730 Sample Changer, Installation 25
2.5.4 Connecting a Printer
Printers with the following printer emulations may be connected:
IBM
IBM Proprinter and printers with IBM emulation
Epson Epson printers and printers with Epson emulation
Seiko Seiko printer DPU-411
Citizen Citizen printer IDP560 RS
HP HP printers and compatibles with HP PCL3 emulation
If you connect a printer not listed in the following table, be sure
that it is able to emulate Epson or IBM Proprinter mode.
Use the 6.2125.050 cable for connecting a printer with built-in se-
rial interface. Printers with parallel interface require the 2.145.0300
serial/parallel converter and 6.2125.020 cable.
Before connecting a printer to the RS232 interface, switch off the
Sample Changer.
The parameters of the RS232 interface are accessible in the con-
figuration menu under '>RS232 settings'.
The following table lists the information necessary for connecting a
printer:
Printer type Cable RS232 Settings Settings on Printer
IBM Proprinter 6.2125.050
baud rate: 9600
data bit: 8
stop bit: 1
parity: none
handshake: HWs
character set: IBM
see printer manual
Seiko
DPU-411
6.2125.020
baud rate: 9600
data bit: 8
stop bit: 1
parity: none
handshake: HWs
character set: Seiko
DIP switch settings:
DIP01 DIP02
on
off
1 2 3 4 5 6 7 8 1 2 3 4 5 6
The 7-bit ASCII character is set automatically
to the specific national character set ac-
cording to the selected dialog language.