Metrohm 730 Sample Changer - Manuel (Page 149)

4.10 Remote Control Commands
730 Sample Changer, Detailed Description
146
4.10.2.30 I nfo.ActualInfo.Pump.1.State
etc. up to .4
Current pump state (on/off).
Pump 1 and 2 on tower 1, Pump 3 and 4 on tower 2.
4.10.2.31 I nfo.ActualInfo.Buret.1.State read only
I nfo.ActualInfo.Buret.1.Position read only
I nfo.ActualInfo.Buret.1.Cock read only
I nfo.ActualInfo.Buret.1.Type read only
I nfo.ActualInfo.Buret.1.Volume read only
etc. until .12
Current data of dosing drive.
State:
Status (ready/busy)
Position: Piston position in mL
Cock: Cock position
Type: Type of dosing unit (685/700)
Volume: Burette volume
4.10.2.32 I nfo.ActualInfo.Inputs.Status read only
Status of the Input lines (Input0…7) of the Remote interface.
$Q sends the signal state as decimal number e.g.
10
⇒ 00001010 binary ⇒ 2 1 + 2 3 ⇒ Input1 and Input3 active
(active = low, inactive = high)
See also page 119ff.
4.10.2.33 I nfo.ActualInfo.Outputs.Status read only
Status of the output lines (Output0…13) of Remote interface. See
4.10.2.32.
4.10.2.34 I nfo.ActualInfo.Display.L1 read only
I nfo.ActualInfo.Display.L2 read only
Text of the first and second line of the LCD display.
4.10.2.35 I nfo.ActualInfo.Counter.Sample read only
I nfo.ActualInfo.Counter.Maximum read only
Currently processed sample number and total number of samples.