Metrohm 730 Sample Changer - Manuel (Page 152)

4.10 Remote Control Commands
730 Sample Changer, Detailed Description
149
.Ch.OM "Opening Moves": Begin of start sequence
.Ch.CM "Closing Moves": Begin of final sequence
.E Error: Message with error number (see page 128.)
Format of AutoInfo messages:
(space)!device name"AutoInfo node"
Example: !Changer1".G"
4.10.2.43 S etup.PowerOn $G
Simulation of "power on". The method last used is ready for op-
eration.
4.10.2.44 S etup.Initialize $G
S etup.Initialize.Select param , config, setup,
assembly, all
Setting of default values for the following branches:
param:
Method parameters (sets empty method
'
∗∗∗∗∗∗∗∗ ')
config: Configuration, branch &Config
setup: Branch &Setup
assembly: Branch &Assembly
all: All values of the entire tree.
Initialization is triggered with &Setup.Initialize $G.
4.10.2.45 S etup.RamInit $G
Initialization of the entire working memory. All parameters will be
set to default; error messages will be deleted (see page 175).
4.10.2.46 S etup.InstrNo.Value 8 ASCII characters
Device number. Essential for service purposes. The device num-
ber must not be altered.