Metrohm 730 Sample Changer - Manuel (Page 148)

4.10 Remote Control Commands
730 Sample Changer, Detailed Description
145
&Info …
4.10.2.26 I nfo.Report $G
I nfo.Report.Select config , param, user meth, all
$G sends the selected report via RS interface.
config:
Configuration report (identifier 'co)
param: Parameter or method report (identifier 'pa)
user meth: Listing of method storage (identifier 'um)
all: Full report
Reports, that are sent from the Sample Changer are marked with
a space (ASCII 32) and the specific report identifier (see above).
4.10.2.27 I nfo.ActualInfo.Lift.1.Exist read only
I nfo.ActualInfo.Lift.1.MaxHeight read only
I nfo.ActualInfo.Lift.1.ActHeight read only
I nfo.ActualInfo.Lift.1.Beaker read only
I nfo.ActualInfo.Lift.2.Exist read only
I nfo.ActualInfo.Lift.2.MaxHeight read only
I nfo.ActualInfo.Lift.2.ActHeight read only
I nfo.ActualInfo.Lift.2.Beaker read only
Current data of lift 1 and 2.
Exist:
Tower exists (yes/no)
MaxHeight: Preset max. height
ActHeight: Current lift position
Beaker: Beaker exists at tower X (yes/no)
4.10.2.28 I nfo.ActualInfo.Rack.Code read only
I nfo.ActualInfo.Rack.Type read only
I nfo.ActualInfo.Rack.WorkHeight read only
I nfo.ActualInfo.Rack.RinseHeight read only
I nfo.ActualInfo.Rack.ShiftHeight read only
I nfo.ActualInfo.Rack.SpecialHeight read only
I nfo.ActualInfo.Rack.ActPos read only
I nfo.ActualInfo.Rack.Act2Pos read only
Current rack data.
Code:
Identification code of the mounted rack
Type: Rack type
WorkHeight: Working position
RinseHeight: Rinsing position
ShiftHeight:
Shifting position
SpecialHeight: Special position
ActPos:
Current rack position at tower 1
Act2Pos: Current rack position at tower 2
4.10.2.29 I nfo.ActualInfo.Stirrer.1.State read only
etc. up to .4
Current stirrer state (on/off).