Troubleshooting - outdoor appliance – DCS Series 7 Liberty Collection 30 Inch Built-In Gas Grill Installation and User Guide Manuel d'utilisation

Page 39

Advertising
background image

37

TROUBLESHOOTING - OUTDOOR APPLIANCE

BEFORE CALLING FOR SERVICE:

If the outdoor appliance does not function properly, use the following checklist before contacting your dealer

for service. You may save the cost of a service call. Troubleshooting is for general purposes only. If the problem

persists and you feel you require service, contact your dealer or the nearest authorized agency to perform service.

Only authorized agencies can perform warranty service.

Call DCS Customer Care at

(888) 936-7872.

Outdoor appliance won’t light

when the control knob is

pushed.

Burner flame is yellow or or-

ange, in conjunction with the

odor of gas.

Low heat with knob in “HI” or

“SEAR” position.

Is the gas supply turned on?

Ensure the outdoor appliance is cool. Remove the

outdoor appliance top grates and the ceramic radiant

trays. Watch the electrode tip. You should see a spark

jump from the tip of the electrode when the ignition

button is pushed.

If there is no spark when ignition button is pushed,

check the battery condition. Battery condition should

be checked at least once a year.

Attempt to match light the burner (see page 27 & 31).

Check to see that other burners on the unit operate.

Clean ignition tip of any debris.

Is it too windy? Wind break is needed.

Check the burner inlet for obstructions such as spider

webs. Check the air shutter for proper adjustment.

Outdoor appliance may be in a dusty area. Move to

less dusty area if possible.

If only one of th burners appears low, clean the orifice

and burner, clearing ports of any obstruction (see

page 34).

Outdoor appliance may be in a dusty area. Move to

less dusty area if possible.

Check for proper gas supply and pressure.

Pre-heat outdoor appliance for a full 15 minutes.

If using LP gas, check for empty tank.

Regular checkup. Turn all knobs to “OFF”, turn gas

supply “off”. Wait 5 minutes. Ensure all knobs are “off”.

Then turn gas supply “on” and wait 30 seconds. Then

attempt to light the burners.

Wind is blowing heat away from the food.

PROBLEM

WHAT TO DO

EN

Advertising