DCS Series 7 Liberty Collection 30 Inch Built-In Gas Grill Installation and User Guide - Manuel (Page 33)

31
USING THE GRIDDLE
LIGHTING INSTRUCTIONS
Push in and turn griddle control knob to “HI” position. Pushing control knob in activates the ignition module and
produces repeated sparking at burner igniter. Holding control knob in also opens the integral safety valve used
for this section and starts the flow of gas to burner. Once burner is lit, continue to hold in the control knob for 10
seconds, or until burner remains lit after control knob is released. The knob can then be turned to desired posi-
tion.
MATCH LIGHTING
Insert a paper book match (DO NOT LIGHT) securely into the clip end of the match extension rod. Light the match
held on the end of the rod and hold up against the bottom of the flash tube on the left side of the flue cover (Fig.
57). Push, turn and hold the griddle control knob to “HI”. Once burner is lit, continue to hold in the control knob
for 10 seconds, or until burner remains lit after control knob is released. The knob can then be turned to desired
position. If the burner does not light after 4 seconds, turn the knob “OFF”. Wait 5 minutes for any accumulated gas
to dissipate before trying to light the burner again.
Fig. 57
EN