DCS Series 7 Liberty Collection 30 Inch Built-In Gas Grill Installation and User Guide - Manuel (Page 31)

29
USING THE SIDE BURNER
LIGHTING INSTRUCTIONS
First remove the cover and any cooking utensils from the burner grate. Check to see if the burner cap is on cor-
rect. Push, turn and hold the control knob in at the “HI” position until the burner is lit or 4 seconds pass
(Fig. 55). If the burner doesn’t ignite, wait 5 minutes for any accumulated gas to dissipate then try again. If the
burner will not light after several attempts, check the troubleshooting instructions on page 36.
MATCH LIGHTING
Hold a paper book match near the burner ports, turn the control knob counterclockwise to “HI”. Rotate the knob
immediately once the burner is lit to the desired setting.
Note:
If you are using propane gas, a slight pop or flash may occur at the burner ports a few seconds after the burner has been
turned “off”. This “extinction pop” is normal for propane gas.
Fig. 55
Control
Knob
EN