Grass Valley OCP 42 User Manual - Manuel (Page 176)

176 Chapter 2 -OCP 42/OCP 50 Operating Instructions
OCP 42/OCP 50 memory card & memory key
B1500M24LA
September 2000
THOMSON OCP 42/OCP 50
User manual
- 1 to 24: the settings stored for camera x (where x is between 1 and 24) will be transferred
to the cameras selected on the MSP, regardless of their number.
- NO STUDIO: wrong card type.
- NO FILE: blank card.
- NO CARD: no card present in the card reader.
• WRITE CAM: selecting this function using the corresponding operating key has the
following effect:
- With an OCP 50: transfers the settings indicated and selected in ‘TFR TYPE’ and ‘CARD
FILE’ to the camera(s) selected using the MSP.
- With an OCP 42: transfers the settings indicated and selected in ‘TFR TYPE’ and ‘CARD
FILE’ to the camera connected to the equipment (the selection ‘CARD FILE = STUDIO’
is not authorised).
During the writing, the following page displays:
• ABORT: selecting this function using the corresponding operating key returns you to the
previous page.
2.7.2.4 - ‘Camera to card’ transfer
In general terms, this function is used to store certain settings for a single digital type camera
on the card.
The call of the camera main transfert is made in the SETTING CAMERA:
WR I T I NG CAME RA
I N P ROGR E S S . . . .
P l e a s e w a i t
OC P CCU
x . x x x . x x
x . x x x . x x
MS P CAME RA
RA T I O GAMMA L AW
4 / 3 F AC T
1 E BU
LEN S F I L E MA S K . L AW
B L K S HAD D I AGNOS E
CAM CARD ME NU S
R E CA L L S T OR E
CAME RA CARD
NEXT (OCP key)
SETTING
(OCP key)