Ohaus I10 Indicator - Manuel (Page 44)

44
Chapter 5: Chapter 5: Chapter 5: Chapter 5: Chapter 5:
Calibration Calibration Calibration Calibration Calibration
The I 10 must be calibrated after
Program Constants have been ini-
tially set, and when any of the
Program Constants are changed
(see Chapter 3 - Program Con-
stants). Calibration is accessed
from the Setup mode.
Before beginning calibration you
will need to have the following
items on hand:
•
a calibration weight equal to the
Calibration Point entered in the
Program Constants menu (see
Chapter 3)
•
If linearization will be performed,
a weight equal to 1/2 of the
Calibration Point will also be
required
•
the screwdriver which was pro-
vided with the
I 10 (not required
for factory calibrated bench
scales; -C0 models).
☞
Only 2 point calibration is
available for Legal For Trade
installations.
The rear cover of the I 10 must be
removed before calibrating if the
SETUP switch is set to OFF. Refer
to
Chapter 1 i f needed.
MODEL CAL WT. (lbs)
LB30-C0 30
LB60-C0 60
PL100-C0 100
PL150-C0 150
WB10-C0 10
WB25-C0 25
WB50-C0 50
FACTORY CALIBRATED FACTORY CALIBRATED FACTORY CALIBRATED FACTORY CALIBRATED FACTORY CALIBRATED
BENCH SCALES BENCH SCALES BENCH SCALES BENCH SCALES BENCH SCALES
If your I 10 is part of a factory calibrated
bench scale setup (-C0 model number
suffix), the weights listed below are
recommended to perform calibration.
5 5 5 5 5 Calibration