Ohaus I10 Indicator - Manuel (Page 43)

43
Setting Program Options 4 4 4 4 4
Address Address Address Address Address
21. When is released, “Adr” will
flash followed by its current setting,
ON or OFF.
22. To change the status press .
23. To accept the displayed status,
press .
24. If the address is set to ON, the
current address will be displayed
when is released.
This will be a 2-digit number be-
tween 00 and 99 with the first digit
flashing. To change the address,
use the front panel buttons as fol-
lows:
Press to increment flashing
digit(s).
Press to shift to next digit.
Press to reset display to origi-
nal setting.
25. When the desired address is dis-
played, press to accept it and
return to the Setup mode.
To return to the weighing mode, press
when “SEtUP” is displayed, or
proceed to another program option.
WHEN TO USE THE ADDRESS WHEN TO USE THE ADDRESS WHEN TO USE THE ADDRESS WHEN TO USE THE ADDRESS WHEN TO USE THE ADDRESS
When multiple indicators or scales
are used in a system where they
share the same RS232 link, the
address feature allows you to
assign an identifying number to
each unit. The number you assign
will be sent along with other data
when the indicator responds to a
print command.
Flashing