Ohaus I10 Indicator - Manuel (Page 36)

36
1. Turn Custom Units ON, then press
to accept the ON status.
2. When is released, “CdP” will
flash then the current custom unit
decimal position will be displayed.
3. To change the position of the deci-
mal point, press .
4. When the decimal point is in the
correct position, press to ac-
cept it.
5. When is released,
“CFACt” will flash then the current
conversion factor will be displayed
with the first digit(s) flashing.
6. Enter your conversion factor using
the front panel buttons as follows:
Press to reset display to all
zeroes.
Press to increment flashing
digit(s).
Press to shift to next digit.
When all digits have been set, press
to accept the displayed conver-
sion factor and proceed to the Parts
Counting indicator.
Press UNITS to
shift decimal
point.
Flashing
4 4 4 4 4 Setting Program Options