Ohaus I10 Indicator - Manuel (Page 42)

42
Selecting Interval - “IntEr” Selecting Interval - “IntEr” Selecting Interval - “IntEr” Selecting Interval - “IntEr” Selecting Interval - “IntEr”
15. If “IntEr” is selected, the current
interval will be displayed with one
digit flashing. The interval is shown
in terms of display updates. “int10”
means that data will be output every
10 display updates.
The duration of display updates is
determined in the averaging level
option. For example, if averaging
level is set to 1, the display is up-
dated every 200 milliseconds. An
interval setting of 10 would cause
data to be output every 2 seconds.
16. To change the interval, use the front
panel buttons as follows:
Press to increment flashing
digit(s).
Press to shift to next digit.
Press to reset display to origi-
nal setting.
17. To accept the displayed setting,
press .
Baud Rate Baud Rate Baud Rate Baud Rate Baud Rate
18. When is released,
“bAud” will flash followed by the
current baud rate setting. Baud rate
may be set to 300, 1200 or 9600.
19. Repeatedly press until the
desired baud rate is displayed.
20. Press to accept the setting.
Flashing
4 4 4 4 4 Setting Program Options