Ohaus I10 Indicator Manuel d'utilisation
Page 41
41
Auto Print
Auto Print
Auto Print
Auto Print
Auto Print
9.
When
is released,
the words “Auto” then “Print” will be
displayed followed by one of the
settings in the adjacent table.
Off:
Off:
Off:
Off:
Off: disables Auto-Print; data is output
only upon request
On Stability:
On Stability:
On Stability:
On Stability:
On Stability: data is output whenever
I
10 changes from an unstable to
stable condition
Continuous:
Continuous:
Continuous:
Continuous:
Continuous: data is output continu-
ously; speed is based on baud rate
Interval:
Interval:
Interval:
Interval:
Interval: data is output at specified
number of display updates; frequency
of updates is the setting selected in
averaging level
10. To change the setting, press
.
11. Press
to accept the dis-
played setting.
If On Stability was selected, con-
tinue with step 12.
If Interval was selected, proceed to
step 15.
If Off or Continuous was selected,
proceed to step 18.
Selecting On Stability - “StAb”
Selecting On Stability - “StAb”
Selecting On Stability - “StAb”
Selecting On Stability - “StAb”
Selecting On Stability - “StAb”
12. If “StAb” is selected, the words
“ZErO” then “bAnd” will be displayed
followed by the current setting, ON
or OFF.
Zero band restricts transmission if
the change in load is less than 10
divisions.
13. To change the setting press
.
14. To accept the displayed setting,
press
.
Setting Program Options
4
4
4
4
4