Metrohm 799 GPT Titrino - Manuel (Page 142)

3.2. Remote control commands
799 GPT Titrino
138
│ "Info", continuation
├ .ActualInfo Current data
│ ├ .Inputs I/O Inputs
│ │ ├ .Status Line status read only 3.2.2.140.
│ │ ├ .Change Change of line status read only ditto
│ │ ├ .Clear Clear change $G ditto
│ ├ .Outputs as for I/O Inputs
│ ├ .Assembly From Assembly
│ │ ├ .CyclNo Cycle number read only 3.2.2.141.
│ │ ├ .Counter Assembly counter read only 3.2.2.142.
│ │ │ ├ .V Volume counter read only ditto
│ │ │ ├ .Clear Clears counter $G ditto
│ │ ├ .Meas Measured value read only 3.2.2.143.
│ ├ .Titrator From Titrator
│ │ ├ .CyclNo Cycle number read only 3.2.2.144.
│ │ ├ .V Volume read only ditto
│ │ ├ .Meas Measured indicator voltage read only ditto
│ │ ├ .dVdt Volume drift dV/dt read only ditto
│ │ ├ .dMeasdt Measured value drift read only ditto
│ │ ├ .dMeasdV 1st deviation of titration curve read only ditto
│ │ ├ .ERC ERC from DET read only ditto
│ │ ├ .T Temp.as secondary meas. read only ditto
│ ├ .MeasPt Entry in measuring point list
│ │ ├ .Index Index of entry read only 3.2.2.145.
│ │ ├ .X X coordinate read only ditto
│ │ ├ .Y Y coordinate read only ditto
│ │ ├ .Z1 Z1 coordinate read only ditto
│ │ ├ .Z2 Z2 coordinate read only ditto
│ ├ .EP EP entry
│ │ ├ .Index Index of entry read only ditto
│ │ ├ .X X coordinate read only ditto
│ │ ├ .Y Y coordinate read only ditto
│ ├ .Oven Oven data
│ │ ├ .HeatTime Heating time read only 3.2.2.146.
│ │ ├ .SampleTemp Sample temperature read only ditto
│ │ ├ .LowTemp Lowest temperature read only ditto
│ │ ├ .HighTemp Highest temperature read only ditto
│ │ ├ .GasFlow Gas flow read only ditto
│ │ ├ .UnitFlow Unit of gas flow read only ditto
│ ├ .Display Display
│ │ ├ .L1 Text line 1 up to 32 ASCII char 3.2.2.147.
│ │ ├ up to line 8
│ │ ├ .DelAll Delete display $G ditto
│ ├ .Comport Comport
│ │ ├ .Number COM where PC is connected read only 3.2.2.148.
│
├ .Assembly Assembly
│ ├ CycleTime Cycle time read only 3.2.2.149.
│ ├ ExV Volume of Exchange/Dosing unit read only ditto