Rockwell Automation 1440-DYN02-01RJ XM Dynamic Measurement Module - Manuel (Page 91)

91 Publication ICM-UM002F-EN-E - March 2013
91
Appendix
A
I/O Data Tags
This appendix describes the module-defined data types for the
1440-DYN02-01RJ standard vibration measurement type. The
module-defined data types are automatically created when you configure the
XM module using the RSLogix 5000 software Add-on Profile.
Tag Names and Definitions
The set of tags associated with any module depends on the module type and
the selections you make in the Module Definition dialog box in the AOP. For
each module you create, specific instances of these data types are created.
These sets of tags apply:
• Input - diagnostic, alarms, and measurements to be sent from the XM
module to the Logix controller
• Output - data sent from the Logix controller to the XM module to
multiply Alarm Limits, unlatch the virtual relay, and reset the maximum
speed measurement
• Configuration - data created with the XM module AOP to configure
your transducers, filtering, measurements, and set alarm limits
The table below shows the tag and main module type for the
1440-DYN02-01RJ standard dynamic measurement type.
(1) The input data tag is dynamically created by the measurements you select in the Channel Data tab in the
Module Definition dialog box. The input data type name varies slightly depending on which measurements you
select.
Topic Page
Tag Names and Definitions 91
Module-defined Data Types 92
1440-DYN02-01RJ Tags
Tag Main Module Defined Type Subtype Used by Main Type
Input
AB:1440_VDP_7FFFFFFF:I:0
(1) None
Output AB:1440_VDP:O:0 None
Configuration AB:1440_VDP:C:0 AB:1440_VDP_ChConfig_Struct.C:0
AB:1440_VDP_AlarmConfig_Struct:C:0