Rockwell Automation 1440-DYN02-01RJ XM Dynamic Measurement Module - Manuel (Page 88)

88 Publication ICM-UM002F-EN-E - March 2013
Chapter 4 Troubleshoot the Module
Module Status (MS)
Indicator
The following table describes the module status indicator.
Network Status (NS)
Indicator
The following table describes the network status indicator.
Channel 0 and Channel 1
Status Indicators
The following table describes the channel indicators.
State Probable Cause
Off No power applied to the module.
Alternating Red/Green Module performing power-up self-test.
Flashing Red
• Application firmware is invalid or not loaded.
Download firmware to the module.
• Firmware download is currently in progress.
Solid Red An unrecoverable fault has occurred. The module may
need to be repaired or replaced.
Flashing Green
Module operating in Program Mode, not performing its
monitoring functions.
Solid Green Module operating in Run Mode, performing its monitoring
functions.
State Probable Cause
Off Module is not online.
• Module is autobauding.
• No power applied to the module; look at Module
Status LED.
Flashing Red One or more I/O connections are in the timed-out state.
Solid Red Failed communications (duplicate MAC ID or bus-off).
Flashing Green Module is online but no connections are currently
established.
Solid Green Module is online with connections currently established.
State Probable Cause
Off
• Normal operation within alarm limits on the channel.
• No power applied to the module. Look at Module
Status LED.
Solid Yellow An alarm associated with this channel is in Alert.
Solid Red An alarm associated with this channel is in Danger.
Flashing Red A transducer fault exists on the channel. The DC bias is
outside the DC Low and High Limits.