Rockwell Automation 1440-DYN02-01RJ XM Dynamic Measurement Module - Manuel (Page 81)

Publication ICM-UM002F-EN-E - March 2013 81
Configure XM Module in RSLogix 5000 Software Chapter 3
4. When finished, click one of these as needed.
• OK - Click to accept your edits and close the dialog box.
• Cancel - Click to close the dialog box without accepting your edits.
• Apply - Click to accept and apply your edits on any dialog and
continue editing.
Configure the Relay Properties
Use the Relay tab to configure the virtual relay for the Dynamic Measurement
module. The Relay parameters control the operation of the virtual relay. Use
these parameters to configure the alarm(s) associated with the relay and the
behavior of the relay.
1. From the Module Properties dialog box, click the Relay tab.
TIP
Hereafter, any reference to the relay implies a virtual relay.