Tweco 7-3472 - Manuel (Page 2)

Date: February 28, 2003 / 28 Février, 2003 2 Manual/Manuel 0-2925
8. Connect the ATC Adapter lead connections to the Torch
Adapter Kit parts installed onto the Power Supply as de-
scribed in the instructions supplied with the Torch Adapter
Kit.
WARNING
The shield connectors on the Adapter Leads should be
connected to the power supply in accordance with in-
structions provided by the power supply manufacturer.
Use of a shielded torch on power supplies not specifically
designed for shielded leads may result in damage to the
power supply and/or improper function.
9. Tighten the Strain Relief onto the ATC Adapter Leads.
10. Connect the RPT Torch ATC connector to the ATC Adapter
connection. The connectors should push together with a
very small amount of pressure. Secure the connection by
turning the locking nut clockwise until it stops. DO NOT
use the locking nut to pull the connection together.
11. Reinstall any covers removed, see WARNING.
12. Install the proper torch consumables for the Power Supply
amperage.
13. Reconnect input power to the Power Supply and turn ON
the unit.
14. Set proper gas pressure or flow.
15. Test torch for proper operation.
NOTE
Every effort has been made to provide complete and
accurate information in this manual. However, the
publisher does not assume and hereby disclaims any
liability to any party for any loss or damage caused
by errors or omissions in this manual, whether such
errors result from negligence, accident or any other
cause.
WARNING
Make sure that the Control Connector Plug
wires DO NOT contact the Adapter Fitting
after all leads are connected.
Pilot Lead
ATC Adapter
Negative/Plasma
Lead
A-03419
Torch Control
Connectors
Control Shield
Connector
Lead Shield
Connector