Tweco 7-3435 - Manuel

Date: September/Septembre 6, 2002 1 Manual/Manuel 0-2730
General Information
This Replacement Torch Adapter Kit is to be used to connect the Thermal Dynamics Plasma RPT Series Cutting Torch
to the following equipment:
• L-TEC PCM-750i, Green Unit, and PCM-1000I, Green Unit
• ESAB PCS-53, 80 and 90
Parts Supplied
The following parts are included in this kit:
• Control Connector Plug with Connectors - 1 ea
• Adapter Fitting - 1 ea
• Pilot Connector Plug - 1 ea
• Pilot Connector Jumper Wire - 1 ea
• Protective Boot - 1 ea
Manual 0-2730
RPT Adapter Kit
Catalog # 7-3435
Installation Instructions
© 1998 Thermal Dynamics Corp., Printed in USA
82 Benning Street, West Lebanon, NH 03784 USA
(603) 298-5711 • www.thermal-dynamics.com
Torch Control
Connectors
Pilot Lead
(Must Remove Ring Terminal)
Torch Lead Assembly
Negative/Plasma Lead
A-02266
Adapter Fitting
Control Connector
Plug with Connectors
To
Po
wer Supply
(-) Fitting
To
Po
wer Supply
Control Connector
To
Po
wer Supply
Pilot Connector
Pilot Connector Plug
Installation
Install the Adapter Kit per the following procedure:
1. Turn OFF the power supply.
2. Disconnect the main input power to the power supply.
3. Remove the existing torch from the power supply, removing covers as required.
4. Slide the Protective Boot, included in this kit, over the end of the Negative / Plasma Lead.
5. Place the Adapter Fitting provided into the Power Supply torch power cable fitting (-) and tighten securely.