Tweco 7-3426 - Manuel

Date: September/Septembre 6, 2002 1 Manual/Manuel 0-2733
General Information
This Replacement Torch Adapter Kit is to be used to connect the Thermal Dynamics Plasma RPT Series Cutting Torch
to the following equipment:
• ESAB EPS-100i
• HOBART SMOOTHCUT 50, Single Gas, and SMOOTHCUT 1000
• L-TEC PCM-50A, 70, 80, 82i, 84i, 100, Single Gas, ESP-100I and 52i/54i
• L-TEC PCM-50 and PCM-100, Dual Gas
Parts Supplied
The following parts are included in this kit:
• Control Connector Plug with Connectors - 1 ea
• Adapter Fitting - 1 ea
• Pilot Adapter Fitting - 1 ea
• Protective Boot - 1 ea
Installation
Install the Adapter Kit per the following procedure:
1. Turn OFF the power supply.
2. Disconnect the main input power to the power supply.
3. Remove the existing torch from the power supply, removing covers as required.
4. Slide the Protective Boot, included in this kit, over the end of the Negative / Plasma Lead.
5. Place the Adapter Fitting provided into the Power Supply torch power cable fitting (-) and tighten securely.
Manual 0-2733
RPT Adapter Kit
Catalog # 7-3426
Installation Instructions
© 1998 Thermal Dynamics Corp., Printed in USA
82 Benning Street, West Lebanon, NH 03784 USA
(603) 298-5711 • www.thermal-dynamics.com
Torch Control
Connectors
Pilot Lead
Torch Lead Assembly
Negative/Plasma Lead
A-02492
Adapter Fitting
Control Connector
Plug with Connectors
To
Po
we
r Supply
(-) Fitting
To
Po
we
r Supply
Control Connector
To
Po
we
r Supply
Pilot Connector
Pilot Adapter Fitting