Tweco 7-3452 - Manuel

October 31, 2002 / 31 Octobre, 2002 1 Manual / Manuel 0-2876
Manual 0-2876
Remote Pendant Interface
RPT Adapter Kit
Catalog # 7-3452
Installation Instructions
General Information
This kit allows any RPT Torch Adapter Kit to be inter-
faced with a Remote Pendant Control. The kit can be
used with any Mechanized Torch System with unshielded
leads.
Parts Supplied
The kit includes:
• Remote Pendant Adapter
• Jumper Assembly (for use with 2-wire leads assem-
blies only)
• Instructions
Installation
1. Turn OFF the power supply.
2. Disconnect main input power to the power sup-
ply.
3. Remove the existing torch and strain relief from
the power supply, removing covers as required.
© 2001 by Thermal Dynamics Corp., Printed in USA
4. On the RPT Torch remove the Strain Relief Nut
from the Strain Relief.
5. The Remote Pendant Adapter must be installed
as follows (refer to illustrations):
a. Connect the Control Connector Plug (refer to
NOTE) to the Power Supply.
NOTE
The Control Connector Plug is supplied in an ad-
ditional RPT Torch Adapter Kit and is required to
complete the installation to the Power Supply.
b. Route the Remote Pendant Adapter connec-
tors on the end of the adapter wiring through
the Strain Relief Nut.
c. Continue routing the adapter wiring through
the hole in the front of the Power Supply.
d. Feed the end of the torch lead and the Strain
Relief into the access hole in the power sup-
ply.
e. Route the wires of the adapter into the notch
of the Strain Relief.
f. Tighten the Strain Relief Nut to secure the
Strain Relief to the Power Supply.
82 Benning Street, West Lebanon, NH 03784 USA
(603) 298-5711 • www.thermal-dynamics.com
Torch Control
Connectors
Torch Lead Assembly
A-03226
Control Connector
Plug with Connectors
To Power Supply
Control Connector
To Remote
Pendant Control
Adapter Kit
Chassis Ground
NOTE
There are various types of
Control Connector Plugs. Signal
START
Ground
Pins
3 & 4
13
Strain Relief Nut
Connection Details
Shown Separately