Tweco 7-3447 - Manuel

October 6, 2004 / 6 Octobre 2004 1 Manual / Manuel 0-2828
General Information
This Replacement Torch Adapter Kit is to be used to connect the Thermal Dynamics Plasma RPT Series Cutting Torch to
the following equipment:
• Thermal Dynamics PakMaster XL Series, PakMaster XL Plus Series and CutMaster 80XL
Parts Supplied
This kit includes:
• Control Connector Plug with Connectors
• Through-Hole Protector
• Instructions
Installation
Install the Adapter Kit as follows:
1. Turn OFF the power supply.
2. Disconnect the main input power to the power supply.
3. Remove the existing torch from the power supply, removing covers as required.
4. The Through-Hole Protector included in this kit is a device to prevent damage to the Torch Leads resulting from a
direct through panel exposure. All plasma cutting systems may not be equipped to utilize this Through-Hole
Protector.
On units where the Through-Hole Protector can be used, install as follows:
a. Remove the retaining nut from the Through-Hole Protector.
b. Place the end of the Through-Hole Protector into the hole in the unit.
c. Secure the Through-Hole Protector to the Power Supply with the retaining nut.
d. Loosen the leads capture nut on the outside of the Through-Hole Protector.
e. Feed the torch lead ends through the Through-Hole Protector and into the unit.
f. Tighten the leads capture nut to secure the Through-Hole Protector onto the Torch Leads.
Manual 0-2828
RPT Adapter Kit
Catalog # 7-3447
Installation Instructions
© 2000 Thermal Dynamics Corp., Printed in USA
82 Benning Street, West Lebanon, NH 03784 USA
(603) 298-5711 • www.thermal-dynamics.com