Tweco 7-3465 - Manuel (Page 2)

June1, 2004 / 1 Juin, 2004 2 Manual / Manuel 0-4646
3a. SL100 Machine Torches with O2B fittings include a remote pendant adapter assembly. This adapter must be installed
along with the torch leads to enable torch operation controlled by a remote pendant.
Torch Control
Connectors
Adapter Kit
Chassis Ground
Signal
START
Ground
Pins
3 & 4
13
Connector
Jumper Assembly (Not Used in All Applications)
Art # A-04014
Remote Pendant Adapter Kit (included with SL100 Machine Torch with O2B Connectors)
4. Refer to the illustration. Pass the end of the Torch Leads or ATC Adapter Kit through the Through - Hole Protector, then
through the Torch Adapter Connection Cover. Pass the end of the Leads or ATC Adapter Kit through the Through-Hole
Protector Nut.
CAUTION
When installing SL100 Machine Torch with O2B connector, also pass the remote pendant adapter (included with
the torch) through the Connection Cover.
5. Slide the nut along the leads or Adapter Kit to position it against the inside surface of the Connection Cover. Secure the
nut to the Through-Hole Protector Assembly. Do not tighten the Through - Hole Protector dome nut onto the leads.
Torch Leads
Assembly
Through-Hole
Protector Assembly
Or
Torch Adapter
Connection Cover
Through-Hole
Protector Securing Nut
ATC Adapter Kit
Art # A-04008
Remote Pendant Adapter
(Included only with SL100 Machine
Torch with O2B Connector)
Through-Hole
Protector Dome Nut
Installing Torch Adapter Connector Cover on Torch Leads or ATC Adapter Kit