Metrohm 758 KFD Titrino - Manuel (Page 125)

3.2 Remote control commands
758 KFD Titrino
121
3.2.2.113. Info.ActualInfo.Titrator.CyclNo read only
Info.ActualInfo.Titrator.V read only
Info.ActualInfo.Titrator.Meas read only
Info.ActualInfo.Titrator.dVdt read only
Info.ActualInfo.Titrator.dMeasdt read only
Info.ActualInfo.Titrator.dMeasdV read only
Info.ActualInfo.Titrator.T read only
$Q sends the current values in the following formats:
SET KFT MEAS CAL
CyclNo 127 127 127 127
V(mL) 1.2345 1.2345 - -
Meas:
pH
U, Ipol (mV)
Upol (µA)
T (°C)
3.6(mV)
–345.6
–12.5
-
-
–345.6
–12.5
-
3.345
–345.6
–12.5
25.0
3.345
-
-
-
dVdt (µL/s) 2.5142 2.5142 - -
dMeasdt
pH,U,Ipol (mV/s)
Upol (µA/s)
T (°C/s)
0.7957
0.7957
-
0.7957
0.7957
-
0.7957
0.7957
0.7957
0.7957
-
-
dMeasdV (mV/µL) 10.6326 10.6326 - -
T (°C) - - 25.9 -
NV: Not Valid. If in the signal drift is OFF in modes MEAS and CAL, the signal
drift is NV.
OV will be sent for "overrange".
A time frame can be set up from the cycle number and the cycle time (see
3.2.2.118). The cycle number is set to 0 at the start of a method and it is in-
cremented until the end of the method.
3.2.2.114. Info.ActualInfo.MeasPt.Index read only
Info.ActualInfo.MeasPt.X read only
Info.ActualInfo.MeasPt.Y read only
Info.ActualInfo.MeasPt.Z1 read only
Info.ActualInfo.MeasPt.Z2 read only
Info.ActualInfo.EP.Index read only
Info.ActualInfo.EP.X read only
Info.ActualInfo.EP.Y read only
$Q sends the last entry into the measuring point list (.MeasPt) or the last entry
into the list of EP's with SET, KFT.
.MeasPt.X"165" Time (SET, KFT, MEAS) of the MPList in s
.MeasPt.Y"3.654" Volume (SET, KFT) of the MPList in mL
.MeasPt.Z1"6.34" Measured value (SET, KFT, MEAS) of the MPList, format
depends on the measured quantity
.MeasPt.Z2"25.8" Temperature of the MPList in °C
.EP.X"1.234" Volume coordinate of the EP
.EP.Y"5.34" Measured value coordinate of the EP