Metrohm 758 KFD Titrino - Manuel (Page 112)

3.2 Remote control commands
758 KFD Titrino
108
3.2.2.48. UserMeth.FreeMem read only
Memory space, available for user methods or silo lines. $Q sends the number
of free bytes, e.g. "4928".
3.2.2.49. UserMeth.Recall $G
UserMeth.Recall.Name up to 8 ASCII characters
UserMeth.Store $G
UserMeth.Store.Name up to 8 ASCII characters
UserMeth.Delete $G
UserMeth.Delete.Name up to 8 ASCII characters
UserMeth.DelAll $G
Management of the internal method memory: Load, store and delete methods.
An action is performed if "$G" is sent to the corresponding node just after en-
tering the name.
Do not use blank characters before and after method name!
.DelAll: Deletes all methods in the user memory.
3.2.2.50. UserMeth.List.1.Name read only
UserMeth.List.1.Mode read only
UserMeth.List.1.Quantity read only
UserMeth.List.1.DosUnit read only
UserMeth.List.1.Bytes read only
UserMeth.List.1.Checksum read only
for each method
List of the methods in the user method memory with the following
characteristics:
.Name: Name of the method
.Mode: Mode
.Quantity: Measured quantity
.DosUnit: Buret of the method
.Bytes: Number of bytes of the user memory used by the method
.Checksum: Checksum of the method, see 3.2.2.104.
3.2.2.51. MemoryCard.Recall $G
MemoryCard.Recall.Name up to 8 ASCII characters
MemoryCard.Store $G
MemoryCard.Store.Name up to 8 ASCII characters
MemoryCard.Delete $G
MemoryCard.Delete.Name up to 8 ASCII characters
Administration of the method memory of the current directory of the memory
card: load, store and delete methods. The action is carried out, if "$G" is
transmitted to the corresponding node.
Do not use blank characters before and after method name!