LG Mega 12,000 BTU Single Zone Mini Split Air Conditioning Unit Owner's Manual Manuel d'utilisation

Page 32

Advertising
background image

32

TROUBLESHOOTING

Problem

Possible Causes

Corrective Action

The air conditioner

does not emit cool

air.

Air is not circulating properly.

Make sure that there are no curtains, blinds, or

pieces of furniture blocking the front of the air

conditioner.

The air filter is dirty.

Clean the air filter once every 2 weeks.

See “Clean the Air Filter” for more information.

The room temperature is too

high.

In summer, cooling the indoor air fully may take

some time. In this case, select the Jet Mode to

cool the indoor air quickly.

Cold air is escaping from the

room.

Make sure that no cold air is escaping through

the ventilation points in the room.

The desired temperature

is higher than the current

temperature.

Set the desired temperature to a level lower

than the current temperature.

There is a heating source

nearby.

Avoid using heat generators like electric ovens

or gas burners while the air conditioner is in

operation.

Fan Mode is selected.

During Fan Mode, air blows from the air

conditioner without cooling or heating the

indoor air.

Switch the operation mode to cooling operation.

Outside temperature is too

high.

The cooling effect may not be sufficient.

The fan speed

cannot be adjusted.

The Jet Mode, or Auto

Operation Mode is selected.

In some operation modes, you cannot adjust

the fan speed. Select an operation mode in

which you can adjust the fan speed.

The temperature

cannot be adjusted.

The Fan Mode or Jet Mode is

selected.

In some operation modes, you cannot adjust

the temperature. Select an operation mode in

which you can adjust the temperature.

The air conditioner

stops during

operation.

The air conditioner is

suddenly turned off.

The Timer Function may have timed out, which

turns the unit off. Check the timer settings.

A power failure has occurred

during operation.

Wait for the power to come back. If you have

the Auto Restart function enabled, your unit will

resume its last operation several minutes after

power is restored.

Advertising