Louisiana Grills 44 Inch Built-In Wood Pellet Grill User Manual - Manuel (Page 22)

22
ENGLISH
PROBLEM CAUSE SOLUTION
Fire in Burn Grate
Will Not Light
Burn Grate Check burn grate for proper positioning. Follow Care and Maintenance for ash build-
up.
Auger Motor Is
Jammed
Remove cooking components from the main barrel. Press the Power Button to turn
the unit on, and inspect the auger feed system. Visually confirm that the auger is
dropping pellets into the burn grate. If not operating properly, call Customer Care for
assistance.
Igniter Not Working
Properly
Remove cooking components from the main barrel. Press the Power Button to turn
the unit on and inspect the igniter. Visually confirm that the igniter is working by
placing your hand above the burn grate and feeling for heat. Visually confirm that
the igniter is aligned with the hole in the burn grate, and open to light the pellets. If
not operating properly, follow Manual Start-up Procedure to continue use of grill;
however, call Customer Care for assistance or a replacement part.
Igniter Failure Igniter needs to be replaced. Contact Customer Care for replacement part.
Readout
Of ACTUAL
Temperature Will
Not Adjust
Grill Probe Dirty Follow Care and Maintenance instructions.
Grill Probe Is
Broken
Grill probe needs to be replaced. Contact Customer Care.
LED Display Has
Wrong Readout
The Temperature
Setting Switch Is
Not Set Correctly
To Read ºC / ºF
Disconnect unit from power source. Remove hopper access panel (see Electric Wire
Diagram for diagram) to access the back of the Digital Control Center. Use a small
flashlight to find the temperature setting switch, located near the center of the back
of the Digital Control Center. Flip the switch to ºC (Celsius) or to ºF (Fahrenheit), as
preferred. Replace hopper access panel.