Sony TA-E9000ES - Manuel (Page 36)

other Settings <CUSTOMIZE>
in
a
a
5‘
IS
Ui
HI
3
a
>
c
VI 1+
3
A
3
Tlio CUSTOMIZK monii >illows \ oii to ciistomi/o wirions
aspocts of the control amplifier 's operation.
■ Video processor mode
Display dimmer control
DVD; PROCESSOR [OFF]
Initial settina : OFF
Lets von route tlie video signals to a \ ideo processor
connected to the PROCESSOR jacks on the rear panel.
• ON : Routes the signals to the PRCXTESSOR jacks.
• OFF : Set to this position when not using the \ ideo
processor, or if \ ou do not connect a \ ideo processor.
■ Audio split (AU SPLIT)
V:VIDE03 A:CD
Use to switch the audio source. (Same as the AUDIO
SPLIT button on the front panel.) See "[3] AUDIO SPLIT
button" on page 13 for details.
■ Audio input mode (AU INPUT)
DVD: AUDIO [AUTO]
Initial setting ; AUTO
Use to switch the input (digital/analog) for the current
component. (Same as the DIGITAL/ANALOG button on
the front panel.) See "[^ DIGITAL/ANALOG button" on
page 13 for details.
■ Digital input mode
DVD; DECODE [ACJTO]
Initial setting; AUTO
Lets you specify the type of signal being input to currently
the selected digital audio jack. The settings are stored
independently for each jack.
• ‘AUTO : The unit automatically switches between
MPEG, DTS, Dolby Digital (AC-3), and PCM.
• AC-3 : All input signals are treated as Dolby Digital
(AC-3) signals. If a MPEG, DTS, or PCM signal is input
to a jack set to AC-3, no sound will be heard.
• DTS ; All input signals are treated as DTS signals. If a
Dolby Digital (AC-3), MPEG, or PCM signal is input to
a jack set to DTS, no sound will be heard.
• MPEG : All input signals are treated as MPEG signals. If
a Dolby Digital (AC-3), DTS, or PCM signal is input to a
jack set to MPEG, no sound will be heard.
DISP. DIMMER XXX“o
Initial setting ; 100"o
Lots you adjust the brightness of the displav window.
It can be adjusted in l'\< steps from 23 to 100''..,
■ Output level
OUTPUT LEVEL [NORM]
Initial setting : NORMAL
Lets vou set the output level.
• NORMAL ; Standard preamp output level (IV).
• LOW : Lowers the output le\ el to 25(1 mV (allowing you
to connect this unit's outputs to another preamp.)
Memory clear
MEMORY CLEAR [YES]
Initial setting : NO
To clear the memory, select [YES] and wait a few seconds.
"Are you sure?" is displayed. Select [YES] again. The unit
automatically turns off, and then turns on again. The
memory is cleared.
■ Sleep timer
SLEEP X:XX:XX
Initial setting: OFF
Lets you set the control amplifier to turn off automatically
after a certain time. Simply select the how long you would
like to wait before the unit turns itself off. Countdown
begins automatically.
To cancel the sleep function, select "OFF" before the count
down is complete.
38 QB