Sony TA-E9000ES - Manuel (Page 2)

WARNING
To prevent fire or shock
hazard, do not expose the
unit to rain or moisture.
Do not install the
appliance in a confined
space, such as a bookcase
or built-in cabinet.
For the customers in United States
A A
ц fHC “Ij:»
« St nv«C»«C. r O OU Ai»I
A
This symbol is intended to alert the user to
the presence of uninsulated "dangerous
voltage" within the prixluct's enclosure
that may be of sufficient magnitude to
constitute a risk of electric shock to
persons.
A
This symbol is intended to alert the user to
the presence of important operating and
maintenance (servicing) instructions in the
literature accompanying the appliance. .
INFORMATION
This equipment has been tested and found
to comply with the limits for a Class B
digital device, pursuant to Part 15 of the
FCC Rules.
These limits are designed to provide
reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses, and can
radiate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that
interference will not occur in a particular
installation. If this equipment does cause
harmful interference to radio or television
reception, which can be determined by
turning the equipment off and on, the user
is encouraged to try to correct the
interference by one or more of the
following measures:
antv'nna.
Inciv.ise the scp.ir.Uiotr bclwcvn the
equipment and control amplifier.
- Connect the equipment into an outlet on
a circuit different from that to which the
control amplifier is coniuvfc'd.
- Consult the dealer or an e\perienced
radio/TV tcvhnician for help.
CAUTION
'f oil are cautioned that any changes or
modification not expressK approved in
this manual could void vour authority to
operate this equipment.
Note to CATV system installer:
This reminder is pro\ ided to call CATV
system installer's attention to Article S20-
40 of the NEC that provides guidelines for
proper grounding and, in particular,
specifies that the cable groqnd shall be
connected to the grounding system of the
building, as close to the point of cable
entry as practical.
Owner's Record
The model and serial numbers are located
on the rear of the unit. Record the serial
number in the space provided below.
Refer to them whenever you call upon
your Sony dealer regarding this product.
Model No. TA-E9000ES
Serial No_______________
For the customers in Canada
CAUTION
TO PREVENT ELECTRIC SHOCK, DO
NOT USE THIS POLARIZED AC PLUG
WITH AN EXTENSION CORD,
RECEPTACLE OR OTHER OUTLET
UNLESS THE BLADES CAN BE FULLY
INSERTED TO PREVENT BLADE
EXPOSURE.
Precautions
On safety
Should am solid object or liquid fall into
the cabinet, unplug the control amplifier
and have it checked by qualified personnel
before operating it an\ further.
On power sources
• Before operating the control amplifier,
check that the operating voltage is
identical with \ our kKal power supply.
The operating \ oltage is indicated on the
nameplate at the rear of the control
amplifier.
• The unit is not disconnected from the AC
power source (mains) as long as it is
connected to the wall outlet, e\ en if the
unit itself has been turned off.
• If you are not going to use the control
amplifier for a long time, be sure to
disconnect the control amplifier from the
wall outlet. To disconnect the AC pow'er
cord, grasp the plug itself; ne\ er pull the
cord.
• AC power cord must be changed only at
the qualified service shop.
On placement
• Place the control amplifier in a location
with adequate ventilation to prevent
heat buildup and prolong the life of the
control amplifier.
• Do not place the control amplifier near
heat sources, or in a place subject to
direct sunlight, excessive dust or
mechanical shock.
• Do not place anything on top of the
cabinet that might block the ventilation
holes and cause malfunctions.
On operation
Before connecting other components, be
sure to turn off and unplug the control
amplifier.
On cleaning
Clean the cabinet, panel and controls with
a soft cloth slightly moistened with a iHild
detergent solution. Do not use any type of
abrasive pad, scouring powder or solvent
such as alcohol or benzine.
If you have any question or problem
concerning your control amplifier
please consult your nearest Sony
dealer.
)Q6