Tweco 7-3464 - Manuel (Page 3)

April 26, 2004 / 26 Avril, 2004 3 Manual 0-4631
5. Connect the connectors on the Control Wire Connectors to mating torch control wire connectors on the Torch
Leads or ATC Adapter Kit.
6.. Slide the Connection Cover along the ATC Adapter Leads or Torch Leads to position it against the Power
Supply front panel. Note that the flange on the bottom edge of the Connection Cover must fit inside the bottom
of the torch connection opening on the power supply. Attach the Connection Cover to the Power Supply with
hardware provided in this kit. Ensure that all wires are inside the Connection Cover.
7. Tighten the Through - Hole Protector Dome Nut onto the Through - Hole Protector securely by hand. Do not
overtighten.
8. In installations using the ATC Adapter, connect the male connector on the Torch Leads to the female receptacle
on the ATC Adapter per instructions provided with the ATC Adapter.
C. Operation
1. Install the proper torch consumables.
2. Connect primary input power. Turn on the gas supply.
3. Set proper gas pressure and flow per the Torch Instruction Manual.
4. Test for proper operation.
NOTE
Every effort has been made to provide complete and accurate information in this manual. However, the
publisher does not assume and hereby disclaims any liability to any party for any loss or damage caused
by errors or omissions in this Manual, whether such errors result from negligence, accident, or any other
cause.