DCS RDT-366 - Manuel (Page 11)

bURNERS
Your new professional gas range is equipped with burners typical of
those used in restaurants. These burners are designed for maximum
cleanability and controllability. The large cap spreads the simmer heat
out to avoid too much heat being concentrated on the center of the
pan. The simmer flame is always “on” when the burner is in use. The
burner should never be operated if the cap is not in place. All the
cooktop burners have electronic spark ignition to eliminate continu-
ously burning pilots; when the burner is on and the flame is blown out,
it will relight.
SIMMERING
Your new professional cooktop has exceptionally
low simmering capabilities. The large cap serves as a
heat diffuser to spread out the heat to avoid having
a center hotspot. keep in mind that because of the
high heat capacity of the retention flame, and the
mass of the cast iron burner grates (they retain heat
longer than lighter, conventional grates) some foods
may continue to cook by retained heat after the
burner has been turned off. should a strong draft or
boil over extinguish the simmer flame it will relight
automatically as the main burner would.
9
COOkTOP USE
sIMMER FlAME
CAP
BRAss
PoRT RING
fig. 04
burner Max. Simmer/Low
Location btu/hr btu/hr
Nat lP Nat lP
1 17,500 15,000 500-1,200 500-1,200
2 12,500 12,500 500-1,200 500-1,200
3 12,500 12,500 500-1,200 500-1,200
4 17,500 15,000 500-1,200 500-1,200
5 17,500 15,000 500-1,200 500-1,200
6 17,500 15,000 500-1,200 500-1,200
1
5
4
3
2
RdT-305 & 485 CookToP sECTIoN sHoWN RdT-366 CookToP sECTIoN sHoWN
RdT-484 CookToP sECTIoN sHoWN
RdT-364 CookToP sECTIoN sHoWN
RdT-486 CookToP sECTIoN sHoWN
3 3
3 3
1
2
1
2
1
2
1
2
4 4
4 4
5
6
5
6