Inserting the batteries, Battery life, To avoid battery leakage – Sony MHC-C9EX Manuel d'utilisation
Page 6: Setting the clock, To check the time while power is on, To correct the clock setting
Attention! Le texte de ce document a été détectée automatiquement. Pour consulter le document original, vous pouvez utiliser le mode "Original".
Inserting the
Batteries .
Install two size AA (R6) batteries in the
supplied remote for remote control.
1
Slide the lid toremove it.
2
Insert two size AA (R6) batteries by
matching the + and - to the diagram
inside the battery compartment and
close the lid.
Battery life
You can expect the remote to operate for
about six months (using Sony SUM-3 (NS)
batteries) before the batteries run down.
When the batteries no longer operate the
remote, replace all the batteries with new
ones.
To avoid battery leakage
If you are not going to use the remote for a
long time, remove the batteries to avoid
damage caused by corrosion from battery
leakage.
Setting the Clock
The built-in clock shows the time in the
display even if the power is off.
5
Press MEMORY/NEXT.
The clock starts running and the upper
dot flashes.
Use the time signal to set the clock
accurately.
"TiV"
flashing
To check the time while power is on
Press CLOCK DISPLAY as many times as
required.
The current time appears.
To correct the clock setting
Repeat steps 1 to 5.
1
Press CLOCK SET.
The "AM" and hour indication begin
flashing.
T
flashing
2
Set the current hour by turning MULTI
CONTROLLER until the correct hour
appears.
Alt
flashing
3
Press MEMORY/NEXT.
The minutes indication begins flashing.
-------
>
^ —
flashing
4 Set the current minute by turning
MULTI CONTROLLER until the correct
minute appears.
flashing
Chapter 1: Setting Up