Sony MHC-C9EX - Manuel (Page 15)

When listening to a tape recorded with the
Dolby* noise reduction system
Set the DOLBY NR selector to B or C (the
same status when it was recorded).
The setting affects both decks. Dolby noise
reduction system reduces tape hiss noise in
low-level high-frequency signals.
* Dolby noise reduction manufactured
under license from Dolby Laboratories
Licensing Corporation.
"DOLBY" and the double-D symbol QD
are trademarks of Dolby Laboratories
Licensing Corporation.
One Touch Play feature
Press O or <1 (or TAPE / ►- on the
remote) when the power is off.
When a tape is in the player, you will
immediately be able to listen to the tape
without pressing any other buttons. If no
tape is inserted, the system will just turn
on.
Automatic Source Selection
If you press l> or <1 (or TAPE / ►
on the remote ) while another source is
selected, the tape player is selected and
play starts automatically.
Recording a CD
You can record from a CD to a tape. Use
any type of tape.
You cannot listen to other sources while
recording.
Recording a CD
Automatically
By using the CD SYNCHRO button, you
can record from a CD to a tape easily.
Use the buttons on the unit for this
operation.
6
5
1
Press = on the tape player and insert a
blank tape into deck B.
Make sure the tabs on the cassette have
not been removed.
Press ^ OPEN/CLOSE on the CD
player and place a CD. Then, press
= OPEN/CLOSE again to close the
tray.
Recording a CD Manually
You can record a CD as you like, for
instance, recording just the songs you want
or recording from the middle of the tape.
You can record a CD using the effect that
you have adjusted.
flashes for a few seconds, then
disappears.
5
If the indicator for the side you want to
start recording does not light, press [>
or <1 to light the side to start
recording.
If it lights, skip to step 6.
6 Press 11 PAUSE on the tape player to
release recording pause.
Recording starts.
To stop recording
Press ■ on deck B or the CD player.
To activate DOLBY NR
When you want to reduce the hiss noise in
low-level high-frequency signals, set
DOLBY NR to B or C after step 3.
Adjusting the volume will not affect the
recording level
But this control will change the sound
levels you hear through the speakers or
headphones.
When you record more than one CD
The tape player automatically runs without
recording and then enters recording pause
mode while the CD player is changing the
disc trays.
When pressing the CD SYNCHRO buttons
during playback, fast-forwarding or
rewinding on deck A
Deck A stops and deck B enters recording
pause mode.
blank tape into deck B.
Make sure the tabs on the cassette have
not been removed.
2
Press ^ OPEN/CLOSE on the CD
player and place a CD. Then, press
= OPEN/CLOSE again to close the
tray.
Total number of tracks and the total
playing time appear in the display.
3
Press EUNCTION to select the CD
player.
4 Select dual or single-sided recording.
15
To record Set DIRECTION to
One side —
Both sides* or RELAY
* Recording always stops at the end of the
reverse side. Be sure to start from the
front side.
5
When you want to reduce the hiss noise
in low-level high-frequency signals, set
DOLBY NR to B or C.
continue to next page -»
Chapter 4: the Tape Player