Ohaus CD-11 Indicator Manual en - Manuel (Page 23)

23
4. OPERATION (Cont.)
4.7 Unit Switch Operation (Cont.)
If enabled in program mode, additional units of measure may be utilized beyond the primary unit of measure used for
callibration or display. Switching between primary and secondary units is accomplished by pressing the Print/Units
button. Which unit is displayed depends on the current units being used. The following tables detail the graduation
size conversions when switching between kg, lb and g.
Cal unit Alternate Unit. Alternate Unit
in Lb
Lb kg g
0.001 0.001 1
0.002 0.001 1
0.005 0.002 2
0.01 0.005 5
0.02 0.01 N/A
0.05 0.02 N/A
0.1 0.05 N/A
0.2 0.1 N/A
0.5 0.2 N/A
1 0.5 N/A
2 1 N/A
5 2 N/A
Cal unit Alternate Unit. Alternate Unit
in Lb
KG LB g
0.001 0.002 1
0.002 0.005 2
0.005 0.01 5
0.01 0.02 N/A
0.02 0.05 N/A
0.05 0.01 N/A
0.1 0.2 N/A
0.2 0.1 N/A
0.5 1 N/A
1 2 N/A
2 5 N/A
5 N/A N/A
4.8 Parts Counting Operation
Parts counting is enabled only when turned ON in the
Readout menu. Refer to paragraph 2.7.5. In the parts
counting mode, the Indicator displays the quanitity of
parts placed on the platform. The Indicator determines
the quanitity based on the average weight of a single
part. All parts must be reasonably uniform in weight for
accurate measurements.
4.9 Establishing a New Average
Piece Weight (APW)
If the APW has not been calculated previously, proceed
as follows:
• Press and hold Print/Units button until Pcs cursor
is displayed.
• Press and hold Zero/Menu until SEtPCS is dis-
played. This is displayed for about 1 second, then
SEt 5 is displayed.
• Select an alternate sample size by pressing and
holding Print/Units button. Choices are 5, 10, 20,
and 50. Place count samples on platform.
Pcs Gross
Brutto
Pcs Gross
Brutto
CD-11 Indicator