Ohaus CD-11 Indicator Manual en - Manuel (Page 21)

21
4. OPERATION
Before using the Indicator, make sure it has been properly set up and calibrated. Refer to Sections 2 and 3 and
review settings. Four buttons are used: ON/OFF - Power on or OFF, PRINT/UNITS - short press prints data, long
press changes unit of measure, ZERO/MENU - short press = 0, long press = enter setup menu, G/N/T/TARE - short
press repeated selects UNITS for display, long press = enter tare.
4.4 Tare Operation
When weighing material or objects that must be held in a
container, taring stores the container weight in the
Indicator’s memory. To store the container weight,
proceed as follows:
• Place the container on the scale. Sample shown is
2kg.
• Press and hold G/N/T Tare button until tArE is
displayed, then release button. Scale is tared and
shows Net weight.
NOTE: Stable cursor must be lit to accept tare
operation.
If the tare weight is removed from the scale, the Net
weight is displayed as a negative value
4.1 Turning On Indicator
• Press and hold On/Off button until the LCD display
appears, then release On/Off button. The display
momentarily displays segment check, the software
revision of the Indicator and then goes into a weigh-
ing mode. If the Indicator has been properly set up
and connected, the display should be as shown to the
left. The decimal point position may be different
depending on the setup of the Indicator.
4.2 Turning Off Indicator
• To turn the Indicator off, press the On/Off button until
OFF is displayed.
4.3 Zero Operation
• Using a short duration press, press Zero/Menu
button to zero the Indicator. The display acknowl-
edges by indicating the selected measuring unit
followed by a zeroed display.
NOTE: Stable cursor must be lit to accept zero
operation.
• Place item to be weighed on the scale platform.
The display indicates a sample of 15kg, gross weight.
Gross Stable
Stable Net
Stable Gross
CD-11 Indicator