Sun Microsystems 806-2989-10 Manuel d'utilisation
Page 43
Chapter 3
Network Configuration
23
6. Shut down and halt the client system.
Use the
shutdown
command to display the OpenBoot (
ok
) prompt.
7. At the
ok
prompt, use the
show-nets
command to find the device path of the
GigaSwift Ethernet device.
The
show-nets
command lists the system devices. You should see the full path
name of the network device, similar to the example below. In this example, the
network@4
device is the Sun GigaSwift Ethernet adapter.
8. At the
ok
prompt, boot the client system using the full device path of the Gigabit
Ethernet device.
For example:
9. Proceed with the Solaris operating environment installation.
Refer to the Solaris Advanced Installation Guide for more information about installing
the Solaris operating environment over the network.
# shutdown -i0 -g0 -y
. . .
(
shutdown
command messages omitted)
. . .
ok
ok show-nets
a) /pci@1f,2000/pci@1/network@4
b) /pci@1f,4000/network@1,1
q) NO SELECTION
Enter Selection, q to quit: q
ok boot /pci@1f,2000/pci@1/network@4