Sun Microsystems 806-2989-10 - Manuel (Page 31)

Chapter 2 Installing the Adapter 11
4. View the .properties file for a list of device properties.
It might be difficult to tell if the devices on your network are GigaSwift Ethernet
devices or other network interface cards. The
.properties command displays the
specific information about the installed adapter.
To make sure that the device you just installed is connected to the network, type:
Note – If you are going to set the local-mac-address property, note the
local-mac-address of your device at this time. See “Setting the local-mac-
address Property” on page 12 for more information.
ok .properties
assigned-addresses 82810010 00000000 00200000 00000000 00200000
82810030 00000000 00400000 00000000 00100000
local-mac-address 08 00 20 e5 bf cf
phy-type mif
max-frame-size 00 00 40 00
address-bits 00 00 00 30
compatible 70 63 69 31 30 38 65 2c 61 62 62 61 00 70 63 69
board-model 501-5902
model SUNW,pci-ce
device_type network
reg 00810000 00000000 00000000 00000000 00000000
02810010 00000000 00000000 00000000 00200000
02810030 00000000 00000000 00000000 00100000
name network
version 1.10
fcode-rom-offset 00000000
66mhz-capable
fast-back-to-back
devsel-speed 00000002
class-code 00020000
interrupts 00000001
max-latency 00000040
min-grant 00000040
revision-id 00000001
device-id 0000abba
vendor-id 0000108e