Sun Microsystems 806-2989-10 - Manuel (Page 37)

17
C H A P T E R
3
Network Configuration
This chapter describes how to edit the network host files after the adapter has been
installed on your system. The chapter contains the following sections:
■ “Configuring the Network Host Files” on page 17
■ “Setting Up a Diskless Client System on a GigaSwift Ethernet Network” on
page 19
■ “Installing the Solaris Operating Environment Over a GigaSwift Ethernet
Network” on page 21
Configuring the Network Host Files
After installing the driver software, you must create a hostname.ce number file for
the adapter’s Ethernet interface. You must also create both an IP address and a host
name for its Ethernet interface in the
/etc/hosts file.
1. At the command line, use the grep command to search the /etc/path_to_inst
file for ce interfaces.
In the example above, the device instance is from a Sun GigaSwift Ethernet adapter
installed in slot 1. For clarity, the instance number is in bold italics.
2. Use the ifconfig command to setup the adapter’s ce interface.
# grep ce /etc/path_to_inst
"/pci@1f,4000/pci@1/network@4" 0 "ce"