Sun Microsystems 806-2989-10 - Manuel (Page 23)

Chapter 1 Product Overview 3
Hardware and Software Requirements
Before using the Sun GigaSwift Ethernet adapter, make sure your system meets the
following hardware and software requirements:
Product Features
You can install or replace the Sun GigaSwift Ethernet adapter. You can also diagnose
a failure using the built-in diagnostic tools.
Key Protocols and Interfaces
The Sun GigaSwift Ethernet adapter is interoperable with existing Ethernet
equipment assuming standard Ethernet minimum and maximum frame size (64 to
1518 bytes), frame format, and compliance with the following standards and
protocols:
■ SNMP (limited MIB)
■ Full- and half-duplex gigabit Ethernet interface
■
Low CPU utilization—Frees up server system resource and bandwidth
■
Dynamic reconfiguration (DR) and redundancy/failover support
■
Full flow control support
■ Duplex SC fiber connector (850 nm, SX)
■ 33/66-MHz, 32- or 64-bit bus master
■ Universal dual voltage signaling (3.3V and 5V)
■ PCI Local Bus Rev 2.2-compliant (6.8-inch x 4.2-inch short card)
■ IPv4 and IPv6 support
■ Load balancing for RX packets among multiple CPUs
■ IEEE 802.1Q VLAN
Hardware and Software Requirements
Hardware Sun Ultra™ 5, 10, 60, 80
Sun Enterprise™ 220R, 250, 420R, 450, 3000/3500, 4000/4500,
5000/5500, 6000/6500, 10000
Sun Blade™ 1000
OpenBoot PROM Revision 3.x, 4.x
Operating environment Solaris 2.6, 7, 8 releases