Cleaning and care, Waveguide cover, Odor removal – Viking 5 Series 1.5 cu. ft. Built-In Microwave Oven Install Guide Manuel d'utilisation

Page 27: Turntable/turntable support, Exterior, Door, Touch control panel, Interior - after microwave cooking, Interior- after convection, mix or broil cooking

Advertising
background image

27

E

E

E

27

E

27

E

27

E

Pr

oduct Car

e

27

WAVEGUIDE COVER

The waveguide cover is made from mica so requires

special care. Keep the waveguide cover clean to assure

good microwave oven performance. Carefully wipe with

a damp cloth any food spatters from the surface of the

cover immediately after they occur. Built-up splashes may

overheat and cause smoke or possibly catch fire. Do not

remove the waveguide cover.

ODOR REMOVAL

Occasionally, a cooking odor may remain in the microwave

oven. To remove, combine 1 cup water, grated peel and

juice of 1 lemon and several whole cloves in a 2-cup glass

measuring cup. Boil for several minutes using 100% power.

Allow to set in microwave oven until cool. Wipe interior

with a soft cloth.

TURNTABLE/TURNTABLE SUPPORT

The turntable, turntable support and racks can be

removed for easy cleaning. Wash them in mild, sudsy

water; for stubborn stains use a mild cleanser and a non-

abrasive scouring sponge. They are also dishwasher-proof.

Use top rack of dishwasher for turntable support.
Foods with high acidity, such as tomatoes or lemons, will

cause the porcelain enamel turntable to discolor. Do not

cook highly acidic foods directly on the turntable; if spills

occur, wipe up immediately.
The turntable motor shaft is not sealed, so excess water

or spills should not be allowed to stand in this area.

Disconnect the power cord before cleaning or leave
the door open to inactivate the microwave oven during
cleaning.

EXTERIOR

The outside surface is painted. Clean the outside with mild

soap and water; rinse and dry with a soft cloth. Do not use

any type of household or abrasive cleaner.

DOOR

Wipe the window on both sides with a damp cloth to

remove any spills or spatters. Metal parts will be easier to

maintain if wiped frequently with a damp cloth. Avoid the

use of spray and other harsh cleaners as they may stain,
streak or dull the door surface.

TOUCH CONTROL PANEL

Care should be taken in cleaning the touch control panel.

If the control panel becomes soiled, open the microwave

oven door before cleaning. Wipe the panel with a cloth

dampened slightly with water only. Dry with a soft cloth.

Do not scrub or use any sort of chemical cleaners. Close

door and touch Stop/Clear pad.

INTERIOR - AFTER MICROWAVE
COOKING

Cleaning is easy because little heat is generated to the

interior surfaces; therefore, there is no baking and setting

of spills or spattering. To clean the interior surfaces, wipe

with a soft cloth and warm water. DO NOT USE ABRASIVE

OR HARSH CLEANERS OR SCOURING PADS. For heavier

soil, use baking soda or a mild soap; rinse thoroughly with

hot water. NEVER SPRAY OVEN CLEANERS DIRECTLY

ONTO ANY PART OF THE MICROWAVE OVEN.

INTERIOR- AFTER CONVECTION,
MIX OR BROIL COOKING

Spatters may occur because of moisture and grease. Wash

immediately after use with hot, soapy water. Rinse and

polish dry. Harder to remove spatters may occur if oven

is not thoroughly cleaned or if there is long time/high

tempera-ture cooking. If so, you may wish to purchase

an oven cleaner pad with liquid cleaner within it—not a

soap filled steel pad—for use on stainless or porcelain

surfaces. Follow manufacturer's directions carefully and be

especially cautious not to get any of the liquid cleaner in

the perforations on the wall or ceiling or any door surfaces.

Rinse thoroughly and polish dry.
After cleaning the interior thoroughly, residual grease may

be removed from the interior ducts and heater by simply

operating the oven on 450˚F for 20 minutes without food.

Ventilate the room if necessary.

Cleaning and Care

1.TINSEB564MRR0_VK-VMOC506_Conv MO U&C_E.indd 27

5/4/18 9:46 AM

Advertising