Sony CMT-M11C - Manuel (Page 40)

Timer-recording radio
programs
To timer-record, you must preset the radio
station (see page 7) and set the clock (see page
6) beforehand. The timer setting will be
released after the radio program is recorded.
The MD is automatically labelled with the
station name, the start time and the stop time
of the recording if the station is labeled (see
page 38) beforehand.
1
Insert a recordable MD in the MD
deck.
2
Press BAND until the band you
want appears.
3
Press TUNING MODE until
"PRESET" appears.
4
Press TUNING -i- or - tu tune in the
preset station.
5
Press TIMER SET.
6
Press TIMER •+• or - until "REG"
appears, then press ENTER.
The hour indication starts flashing.
7 Set the time you want to start
recording.
Press TIMER + or - to set the hour, and
press ENTER,
The minute indication flashes.
Set the minute in the same way, and
press ENTER.
The hour indication for the turn-off time
flashes.
8
Set the time you want to stop
recording following the above
procedure.
9
Press POWER to turn off the power.
To check the setting
Press TIMER SELECT repeatedly until "REC"
appears. The start time, followed by the stop
time and the preset number appears, then the
original display appears. To change the
setting, start again from step 1.
To cancel the timer operation
Press TIMER SELECT repeatedly until
"TIMER OFF" appears.
To change the setting
Repeat steps 1 through 9.
Notes
• If the recordable time for the MD comes to the end
while timer recording, the recording will stop
immediately, and the deck will stop.
• The volume is reduced to minimum during
recording.
41
*