Sony CMT-M11C - Manuel (Page 23)

Programming the MD
tracks
— Program Play
You can make a program up to 25 tracks in
the order you want them to be played.
Set the MD/TAPE switch and MD/CD/
TUNER switch on the remote to MD.
1 Insert an MD.
i2
Press PRCXiRAM in stop mode.
"PGM " appears in the display.
3
Do either
O
or ©.
©Selecting tracks with the number
buttons on the remote
Press the number buttons to enter the
tracks you want to program in the
order you want.
To program a track with a number
over 11, use the >10 button (see page
21 ).
If you've made a mistake
Press CLEAR, then press the correct
number button.
©Selecting tracks while checking the
total playing time
1 Press or ►►►W (!◄◄ or
►W for MD on the remote) until the
track number you want appears in the
display. The total playing time
including the selected track flashes in
the display.
2 Press PROGRAM.
The step number (number of the
playing order) appears for about one
second, then the total playing time
lights up.
4
Repeat step 3 to program additional
tracks.
5
Press Wl (or ► for MD on the
remote).
All the tracks play in the order you
selected.
To cancel the program play
Press CONTINUE.
To change the program
To Do this
2 Add a track at Do steps 3 through 5 in stop
1 the end of the mode.
*- CLEAR program
Clear the entire
program Press ■ for MD in stop mode.
Clear the last Press CLEAR.
program Each time you press the
button, the last track of the
program is cleared.
Tips
• The program you made remains after the Program
Play hSis finished. To play the same program
again, press ► for MD.
• The step number appears in the display by
pressing DISPLAY in stop mode.
Notes
• The program is cleared by pressing ^ on MD deck
to eject the disc.
• "--m—s" appears when the total program time
exceeds 100 minutes.
• If you try to program more than 25 tracks, "MD
FULL" is displayed.
23
^