Garland GPD SERIES GAS PIZZA OVENS - Manuel (Page 7)

Part # 1844063 Rev 1 (01/30/07) Page 7
INSTALLATION continued
Termination Less than 10 feet (3 meters) from ridge Termination More than 10 feet (3 meters) from ridge
Less than 10 feet (3 meters)
More than 10' (3 meters)
2' (60cm)
Min.
3' (90cm) Min.
3' (90cm) Min.
ASSEMBLY INSTRUCTIONS
Leg Installation
On single deck units, tip oven section units back. On double-
deck units, tip lower oven section ONLY on its back. Each leg
is secured with four 3/8” (16mm) hex head bolts, threaded
into nuts located on the underside of the base angle. When
both front legs are installed, lift and block up rear of unit.
Install rear legs.
Hearth Installation
NOTE: Because of the weight of the hearth plates, be very
careful to avoid injury to yourself and to shelf joint edges,
when sliding shelf halves into the oven.
To install hearth core plates or steel hearth assembly,
proceed as follows:
1. Slide the wooden frame out of the oven.
2. Before installing the hearth core plates or steel hearth
assembly, be sure that the bottom heat deflectors are
properly positioned with the treaded side (bumps) in the
up position.
3. If the oven is supplied with a steel hearth assembly, place
the hearth spacers (with the flat side in the up position)
on the extreme left and right sides of the oven resting on
the heat deflectors. Making sure the hearth spacers are
not disturbed, slide the steel hearth assembly into the
oven.
4. If oven is supplied with hearth core plates, slide the plates
into the oven.
GPD-48 is supplied with (2) two hearth core plates.
GPD-60 is supplied with (3) three hearth core plates.
5. Installation instruction for Hearth.
a. Place a screwdriver, or a similar prying device,
between the core plate and hearth frame support,
(being careful not to chip the core plate) then place
two spacer clips (PN G03086-1-9) between the core
plate and the hearth frame support. (See instructions
sheet –PN 1917401) 6” from front & 6” from rear.
b. Place a screwdriver between the back of the right
core plate and hearth frame support. Pry the core
plate forward, away from the hearth support and
place a clip within the space centered on each core
plate.
c. Repeat step 2 for the left core plate
d. Repeat step 3 for the center core plate for 60” unit.