HP StorageWorks 1000i Virtual Library System - Manuel (Page 105)

C. Conformité et sécurité
Cette section contient les avis de conformité relatifs au système de bibliothèque virtuelle HP StorageWorks
1000i.
Numéros d’identification de conformité
À des fins d’homologation et d’identification, ce produit s’est vu attribuer un numéro de série HP. Vous
trouverez sur l’étiquette du produit le numéro de série de votre librairie HP StorageWorks MSL, ainsi
que les marques et informations d’homologation requises. Si l’on vous demande des informations sur
l’homologation de ce produit, communiquez ce numéro de série. Vous ne devez pas le confondre avec le
nom commercial ou le numéro de modèle de votre librairie HP StorageWorks MSL.
Informations spécifiques sur le produit :
• Système de bibliothèque virtuelle HP StorageWorks 1000i
• Numéro de modèle réglementaire SNPRF 0501
• ClassificationFCC et CISPR : classe A
• Ce produit contient une pile bouton (CR 2032) dioxyde manganèse lithium. Cette batterie est
extractible et se trouve sous le déflecteur d’air noir, entre les ventilateurs et le dissipateur thermique du
processeur principal. Ces éléments se trouvent dans le compartiment principal sous le capot supérieur.
• Ce produit n’est pas équipé d’un laser.
Réglementation FCC
Part 15 of the Federal Communications Commission (FCC) Rules and Regulations has established Radio
Frequency (RF) emission limits to provide an interference-free radio frequency spectrum. Many electronic
devices, including computers, generate RF energy incidental to their intended function and are, therefore,
covered by these rules. These rules place computers and related peripheral devices into two classes, A
and B, depending upon their intended installation. Class A devices are those that may reasonably be
expected to be installed in a business or commercial environment. Class B devices are those that may
reasonably be expected to be installed in a residential environment (personal computers, for example).
The FCC requires devices in both classes to bear a label indicating the interference potential of the device
as well as additional operating instructions for the user.
The rating label on the device shows which class (A or B) the equipment falls into. Class B devices have
an FCC logo or FCC ID on the label. Class A devices do not have an FCC logo or FCC ID on the label.
Once the class of the device is determined, refer to the following corresponding statement.
Matériel de classe A
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. Operation of this equipment in a
residential area is likely to cause harmful interference, in which case the user will be required to correct
the interference at personal expense.
Matériel de classe B
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses, and can radiate radio frequency
Système de bibliothèque virtuelle HP StorageWorks 1000i 105