Maytag MHP1000SQ - Manuel (Page 5)

The pedestal arrives with the feet tight against the bottom of the
unit. Using a 1/4 " hex head ratchet or open-end wrench, lower
the feet approximately 1 " away from the bottom of the pedestal.
Tip the washer/dryer back to its upright position. Remove
and discard any remaining packaging material.
COMPLETE THE INSTALLATION
Follow the installation instructions that came with your model
to finish installing or reinstalling your washer/dryer (i.e., hoses,
vents, etc.).
Place a level on top edges of washer/dryer, checking each side
and front. Rock machine back and forth to make sure all four
feet make solid contact with floor.
If not level, adjust pedestal feet up or down, repeating as
necessary.
Locate the 1/4" hex head screws on the top of each pedestal
foot. Reach inside the pedestal and use a 1/4" hex head ratchet
or open-end wrench to adjust the feet up or down as needed to
level the washer/dryer.
5
7.
stand the washer/dryer upright
9.
Check levelness of washer/dryer
10.
adjust pedestal feet
Not Level level Not Level
Place level here
8.
move close to final location
1"
(25 mm)
6.
Prepare pedestal feet